Hello guys! Initially I was inclined to buy the Seamaster 300 pre-2018 model (the one with the dial without wavers) because of the slightly smaller size. However, it seems that it is difficult to find, I read that the best factories were MKF/MKS, but it would seem to be no longer found. So I am heading towards the new model and reading the famous comparison found on the forumit woud seem ZF to be the best. I'm a little afraid though about the problems I've heard about the noisy rotor as I can't solve it myself. I had a problem with my Planet Ocean purchased by Ryan as it just got stuck, but I eventually bought an original ETA 2824 and a watchmaker near me replaced it. Do you think there are worrying problems in ventruring with ZF?
-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
Looking for tips for Omega SMP 300 Blue
- Thread starter LeChiffre007
- Start date
Hey @LeChiffre007. Not sure if you ever found your answer, however you’d be hard to find a ZF SMP300 anymore as they have stopped making them. Your best bet would be VSF or T+F (which are new to making them). Or try to pick up a ZF in the M2M section, one is currently for sale.
