Look what is that!!!

[Kingquest_s]

Finally, it has been 3 years searching for the gen rotor. Today i finally found it and it is half finish gen-like project for the big bang ceramic bezel and carbon fiber dial.

Now im sourcing for ETA balance wheel of 7750 and servicing the movement to complete the project.

The condition of this rotor kinda fair not still good enough. There are oil mark on that, i dont know should i buff it or how to clean it make it like new again. Any opinions or recommendations, please drop your comments blow and help me success the project.

Thank you very much.

Sent from my SM-N986U using Tapatalk

 

[CurioLeo]

Did you come across any SW300 (HUB1110) rotors while looking for this one ?

 

[Kingquest_s]

Did you come across any SW300 (HUB1110) rotors while looking for this one ?

This is rotor for the hublot big bang 44mm. The rotor on SW300 (HUB1110), old classic fusion, came with small HUBLOT font and big center. If u are looking for that, should get the rotor from WWF of JJF better, similar to 06 model.

Sent from my SM-N986U using Tapatalk

 

[CurioLeo]

This is rotor for the hublot big bang 44mm. The rotor on SW300 (HUB1110), old classic fusion, came with small HUBLOT font and big center. If u are looking for that, should get the rotor from WWF of JJF better, similar to 06 model.

Sent from my SM-N986U using Tapatalk

Thanks for the info, Hublot is definitely not a field of expertise for me. I am in the process of building a superfranken Classic Fusion 42mm and was hoping to get hold of a gen rotor to go with my chronometer grade SW300-1 but until I do, I will stick with the rep rotor.