Is it the right CG ?

[Wiz]

Hi everyone,

I have a problem with the CG of my PAM 005 (no contact between crown and lever). A ccording to my watchsmith, the problem is the CG, so I'm looking for a new one.

Is this the right CG for a PAM 005 --> http://www.jacksontse.com/mm087.html

Thanks

 

[LegendofSpeed]

No, it's not.... it's for the Fiddy case... the flat feet would not match the curve of your Luminor case...

 

[Wiz]

So would you know where I could find the right CG ?

Thanks.

 

[sconehead]

I recently bought one off this site for a 111h for $10 shipped with the screws. If you ask for a CG for a 44mm case you'll recieve the correct type, if you're worried about it just contact him and verify you want a plain one. By the way, good comms, very helpful and fast delivery as well. Here's a link to a thread I started about the CG, viewtopic.php?f=7&t=57717&start=0&st=0&sk=t&sd=a
:wink:

@ LOS, I mentioned in the shoutbox to Alviando about this seller that he may be a great candidate to consider for going on probation. He's currently a recommended dealer on another board, he's a great source for cheap parts/movements that will fit our reps. He said he would bring it to the admins attention. As a further example, he pushes out an Asian 6497 with swan neck for £35 delivered worldwide, bang on a Fransisco decal and you're good to go...

 

[Drulee]

I bought my first rep/homage from Jackson back in May, great deal. His $35 USD (incl. delivery) 6497 movement actually has the H3 CP with it (at least in the last two I bought).

I've bought a few CG's (non fiddy style), and find that the titanium ones have had their levers shaved down too much, so they just barely touch the top of the crown. Otherwise they are pretty good - I've tried them on a few other rep cases and they've always fit flush to the case. And at $10 delivered (both SS and ti) they're great to practice on.

 

[Wiz]

Thanks for the info