• Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!

Heritage Black Bay Bezel springs

Jet438

Do not accept unsolicited offers
17/5/19
9
2
0
I'm looking to see where I can get Tudor Heritage Black Bay bezel springs. Both the straight and the click springs (non ball bearing). I took the bezel off to change the insert and lost one of the non click springs. Any help would be greatly appreciated.
 

Jet438

Do not accept unsolicited offers
17/5/19
9
2
0
Ok. I'm an noob idiot but what's a spring bar? Ha I'm quessing your talking about the spring bar for the wrist band, correct? (I'm probably get demoted to something lower than Jumior member for having had to ask - Ha) ...but thank you for the reply
 
Last edited:

Jezz

Getting To Know The Place
29/11/15
62
4
8
Hi
How did you get the bezel off?
I've got a corgeut version with coin edge and can't get the bezel off.
Regards
Jezz
 

Hor-Fan

When the going gets weird
Supporter
Certified
14/1/17
4,764
5,582
113
Bat Country
Hi
How did you get the bezel off?
I've got a corgeut version with coin edge and can't get the bezel off.
Regards
Jezz

Pretty certain the corregut/parnis version has a paper clip spring bezel construction unlike the ZF. You’ll probably have to remove the insert and see if you can unclip the spring from the top side.
 
Last edited:
  • Like
Reactions: Jezz

Jet438

Do not accept unsolicited offers
17/5/19
9
2
0
Well I kind of cheated. I asked the nice people I bought the case from to detach it before they sent it to me. There's a few videos on line on how to do it. You'll need something with a knife edge. make sure to protect both the knife edge and the watch with electrical tape to prevent scratches.
 
  • Like
Reactions: Jezz

Jezz

Getting To Know The Place
29/11/15
62
4
8
Thanks for the info.
I've tried the sharp knife and it won't budge.
I will try to remove the insert.
Thanks again for the help
 

Hor-Fan

When the going gets weird
Supporter
Certified
14/1/17
4,764
5,582
113
Bat Country
Thanks for the info.
I've tried the sharp knife and it won't budge.
I will try to remove the insert.
Thanks again for the help

Heat the insert up with a blow dryer, this will soften the adhesive and make it easier to remove.
 
Last edited:
  • Like
Reactions: Jezz