• Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!

H-Fac Panerai 332 “Expendables” Crystal Upgrade

Lliu31

Renowned Member
Certified
3/2/17
806
205
43
NYC
No longer in production since H fac was raided. They used to sell their 332 I’m default mineral crystal or sapphire upgrade for an extra $140. I got one on the way to me through m2m but it’s on the standard mineral. Anyone know if perhaps a gen crystal or any other rep crystals that would perhaps be a fit? I know there’s always some slight deviation that makes gen components incompatible with reps. If anyone can opine I appreciate it. Thanks!
 

mysterio

Mythical Poster
Advisor
19/8/08
9,794
864
0
I don't recall anyone performing the sapphire upgrade post purchase. Probably best to measure the crystal on your watch and then asking the seller what the dimensions of the crystal are (you can tell him you're planning to use it on a homage).
 
  • Like
Reactions: Lliu31

Lliu31

Renowned Member
Certified
3/2/17
806
205
43
NYC
mysterio Thank you. Any advice on where to start measurements? Vertical and horizontal edge to edge of crystal I presume? Finding the domed is difficult, but standard crystals are a dime a dozen on eBay.
 

mysterio

Mythical Poster
Advisor
19/8/08
9,794
864
0
mysterio Thank you. Any advice on where to start measurements? Vertical and horizontal edge to edge of crystal I presume? Finding the domed is difficult, but standard crystals are a dime a dozen on eBay.

Usually the important dimension is the diameter of the crystal. I cannot speak definitively as I don't do mods or builds, maybe kilowattore or Grimlocktime can chime in on the important measurement. The height and crystal thickness probably would not vary much compared to the gen/aftermarket crystal if the diameter were the same.
 
  • Like
Reactions: Lliu31

kilowattore

Sales Moderator / Section Moderator
Staff member
Moderator Sales
Section Moderator
Certified
11/5/13
13,967
6,418
113
Italy
I have no experience on this, sorry.
As mysterio said, I'd measure the diameter and start from there searching for a compatible domed shape.
 
  • Like
Reactions: Lliu31