• Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!

Glas replacement on a 1680

tribal

Renowned Member
27/3/06
782
600
93
Germany
Hello Guys,
I replaced the Glass on My 1680 with a gen Tropic 127 :Jumpy:
And i must say that was a hard job to do it,because i have no Crystalpress.....
I sarted to lift up the retaining Ring like Ubi do (Ubi thank you for that)....
I took a razorblade to pull up the retaining ring,i pulled around the hole retaining ring...
That was an easy job,after i put off the Ring there was no gasket between the case and the ring :huh:
I put of the old glass, that was easy,also installing the gen one....
I put a gasket between the case and the retaining ring and pushed the ring down.......
.... nothing, i pressed with a plastic ring that matched the case with the Retaing ring ....nothing,not 1mm.
After that i took a screw clamp to push it down and it works... :p

Man, if you don't have the right tools its so difficult to do this.....
I think thats my next purchase....

Ok hard work but its done....
and here the result....

s0064jm.jpg


s0125bo.jpg


s0151mh.jpg


s0189cp.jpg


Damm i love this Vintage Rollies...... :Jumpy:

Next step is to install a Gen Tub and Crown

Hope you like ,opinions are welcome...........

RG Tribal