Gen CG on a rep

[hubrisin]

So right now I am looking at getting a gen G series crown guard. It would be going on a DSN 240 Ti with a lug width of 14.76 mm, will the gen CG fit or will I need to drill and tap?
If so, is there a board member that specializes in that type of mod? Any comments would be helpful, just don't want blow a few hundred on nothing.

 

[hooligan]

I believe DSN's 240 uses a "standard" rep case, so you SHOULD be OK. However, there's no guarantee until you try it. I know there are folks who have successfully fitted gen CGs to non-DSN rep cases, though.

 

[optimis9]

I want the same. The CG is what bother me most, really. Waiting to hear ..............................................

 

[pete2528ca]

i have seen it done. looks pretty good.