Flush CG mod

[1_robbo]

Ok, i had had a good search but can't find anything definative.
Can someone point me in the right direction for a thread regarding getting the CG flush to the case on my new Pam088 GMT, its not miles away but i keep seeing reference to flush CG mods and its sparked my interest as its my first Pam.
Thanks in advance.

 

[COLDI]

http://forum.replica-watch.info/vb/...r-diy-mod-24442?t=24442&highlight=crown+guard

 

[1_robbo]

Thanks dude.

 

[sconehead]

There is a better cg mod IMO. I'll see if the member will allow me to post it over here...

 

[golgi]

I think you're looking for getting the cg flush to the case, not the pin flush in the cg. If that's the case, here's a mod from H_U:

http://forum.replica-watch.info/vb/showthread.php/crown-guard-mod-panny-24238?t=24238

Always remember, a little at a time and then refit. Patience will reward you on this mod!

 

[1_robbo]

I think you're looking for getting the cg flush to the case, not the pin flush in the cg. If that's the case, here's a mod from H_U:

http://forum.replica-watch.info/vb/showthread.php/crown-guard-mod-panny-24238?t=24238

Always remember, a little at a time and then refit. Patience will reward you on this mod!

Thanks golgi thats exactly what i was looking for !
The pin mod is also useful as i have that problem too.
Time to get to work........
Cheers

 

[HR911]

Robbo,

Be careful on the CG pin mod, I tried it on a PAM 127 I bought previously to the one I have now and failed miserably!!

Good luck