Eta 7750 swap in noob pam 243 with A7750

[Klocklind123]

I have a all genuine eta 7750 chrono movement.

I want to use that (eta 7750) in my noob v2 pam 243 with a7750.

Is it possible to remoove the chronoparts from the eta 7750 and use the top bridge from the a7750?

And can I use the center Canon pin from the a7750 and put it on the eta 7750?

Or do I need other parts for this job?

 

[Rx4Time]

You can use the movement without issue. The only incompatible part between replica and genuine ETA is the chronograph seconds hand which does not apply in your case so therefore you should be able to use the stock Canon pinion.

 

[Klocklind123]

Thanks a lot for that quick information

I live in EU is there any good watchmaker that can do a full service and rebuild movement?

 

[Klocklind123]

Regarding the chrono parts from the swiss eta, is it just to remoove those parts?

The eta has the minute/hour conter axels.
Is it possible to just remoove them or do you cut them off to not rub against the dial!

 

[Rx4Time]

Not sure who is taking work, but @Natas78 , @Johnny Depp @ado213 are in your neck of the woods

 

[Deep]

I live in EU is there any good watchmaker that can do a full service and rebuild movement?

@Natas78