vsf also released this model... quality of the photos is not the best but better photos will be available in next few days
Looks like they have fixed those poor crown guards. If this is real vsf...
-
Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!
ERF Releases Omega Seamaster "No Date" 210.30.42.20.01.010 and 210.30.42.20.06.002
- Thread starter Reaps
- Start date
Looks like they have fixed those poor crown guards. If this is real vsf...
You must have missed reading the above post earlier in this thread.
Seems like ERF also missed having the ‘swiss made’ below the 6 o clock indice when compared to gen
- 25/9/22
- 9,125
- 25,338
- 113
You're comparing the wrong models. These no date Seamasters don't have SWISS MADE text at 6.
Introducing: The Omega Seamaster Diver 300M No-Date
Spotted numerous times over the past year or so, the wait is finally over, as Omega releases the Seamaster Diver 300M No-Date.
monochrome-watches.com
My fault, I apologizeYou're comparing the wrong models. These no date Seamasters don't have SWISS MADE text at 6.
Introducing: The Omega Seamaster Diver 300M No-Date
Spotted numerous times over the past year or so, the wait is finally over, as Omega releases the Seamaster Diver 300M No-Date.
- 25/9/22
- 9,125
- 25,338
- 113
Actually, I apologize, we need to do more research, I find both with and without swissmade
Its very confusing lol. I think because the crystal is domed it hides it rather well. But looking at videos of the watch at certain angles you can see it. But other angles it seems non existent
Almost like if its below/in the rehault or chapter ring? So the domed crystal hides it fairly well. I’m not too good at watch terms lol
- 25/9/22
- 9,125
- 25,338
- 113
Gen pics found on reddit. Not sure if ERF missed this during making it. Or we haven’t seen a good picture of ERF’s at the right angle to view it
- 25/9/22
- 9,125
- 25,338
- 113
I was so close to pulling the trigger on getting an ERF but thats the only discrepancy holding me back. Hopefully VSF can make one or ZF.
Same, even got the qc pics but the crystal seems off (milky) and the no Swiss Made at the bottom just sealed it that I won’t be getting an ERF.
If you still have the QC pics do you mind pm-ing them to me? I'd love to take a look. I think I'll hold off until ZF or VSF makes these though. Hopefully soon enough lol