Did my PAM111 V3 come with the wrong screws?

[58285]

So I tried to take my lug screw out today for the first time and one of then would not go back in.

When I checked the screw, it seems to have 'itchings' that the other one don't have...so the dent is stopping it:

View attachment 22167
View attachment 22168

Sent from my GT-I9300 using Tapatalk 4 Beta

EDIT: corrections, it got stuck while trying to take the screw out...

 

[Alex_P1]

Well, it went in so will come out, it just depends how much force you're happy to use...

If you're satisfied that the thread is disengaged, then a tap with a pin and hammer will get it out. You will need to clean it up with either a file or glass paper before reassembling though, and it might take some fiddling to get right, so be sure you want to get it apart before you do!

 

[58285]

just realised the photo doesnt show the screws at all...

Ill just have to describe it, unlike the other screw, this one has 'threads' on it.

I believe that is stopping it since I have a dent on it.

Heres a link to it dropbox photo. https://www.dropbox.com/s/0bptfapbqui3ifw/2013-06-07 19.18.53.jpg

Thanks for your time.

 

[ezempls]

They should screw in and out easily.

I take mine out then run them back through with fingers only w/o the strap in place... Some times from the outside of the threaded lug.

When reinstalling, turn the screw counter clockwise until you feel a "click" then proceed slowly clockwise. This way you will know the thread is engaged properly.

Good luck.

EZ

 

[Pannyforme]

did u initially used a correct sized screwdriver to uncrew it?because if u dont its a common problem that i faced, corrected with a proper screwdriver

 

[58285]

Yes. I did use the correct screws and everything.

I have a dent (as I said) I think that may have caused the problem.

I think I'll ltake it to a watchsmith...again....

Sent from my GT-I9300 using Tapatalk 4 Beta