I found that a dwo swap on the 2824 is more challenging than the 2836. If not done right, it can lead to your dwo sticking or more confusingly shifting off the datewheel itself. This is because the 2824 datewheel is flat. The 2836 dw is not flat and has a higher platform that rides above the level of the movement. The flat 2824 dw literally sits below the level of the keyless works cover, I think it is part 462 in this link
Http://www.ofrei.com/page1232.html
When you attach the dwo, it rubs on that metal cover and dislodges the dwo. The 2836 does not have this problem since the elevation built into the actual datewheel lifts the dwo over this cover.
Solution – elevate the dwo a bit. TC uses dial dots to achieve this and attach his dwo – I don’t like this, it makes it impossible to fine adjust the dwo.
Here is tc dwo with dial dots
Once you remove the movement from the watch, you remove the dial and hands by releasing the tab holding the dial feet, one of the 2 tabs is near the bottom in this pic
Underside pic
My solution, take a piece of sticky paper, such as any labels you can print on. Use the dwo and draw outline of the dwo. Cut the circle out and fold it and cut the inner aspect out. Attach it to the bottom of the dwo but only on the outer perimeter so that the inner perimeter is clear of anything. This simple trick gives you a bit thicker dwo on the outer edge and is enough to elevate the dwo
I use this stuff, as it dries fairly slowly, 5-10 min work time
I use a small amount of the adhesive on the actual datewheel, small amount is key
You then set the dwo on top and place the dial on there, if not well aligned, remove the dial and adjust the dwo, make sure you check the alignment with different dates
At the end, you can have something like this
Tip: use gloves to handle dial so that it is not damaged during this alignment process
Http://www.ofrei.com/page1232.html
When you attach the dwo, it rubs on that metal cover and dislodges the dwo. The 2836 does not have this problem since the elevation built into the actual datewheel lifts the dwo over this cover.
Solution – elevate the dwo a bit. TC uses dial dots to achieve this and attach his dwo – I don’t like this, it makes it impossible to fine adjust the dwo.
Here is tc dwo with dial dots
Once you remove the movement from the watch, you remove the dial and hands by releasing the tab holding the dial feet, one of the 2 tabs is near the bottom in this pic
Underside pic
My solution, take a piece of sticky paper, such as any labels you can print on. Use the dwo and draw outline of the dwo. Cut the circle out and fold it and cut the inner aspect out. Attach it to the bottom of the dwo but only on the outer perimeter so that the inner perimeter is clear of anything. This simple trick gives you a bit thicker dwo on the outer edge and is enough to elevate the dwo
I use this stuff, as it dries fairly slowly, 5-10 min work time
I use a small amount of the adhesive on the actual datewheel, small amount is key
You then set the dwo on top and place the dial on there, if not well aligned, remove the dial and adjust the dwo, make sure you check the alignment with different dates
At the end, you can have something like this
Tip: use gloves to handle dial so that it is not damaged during this alignment process
