Hello,
After several hours of thinking I was in over my head... I finally hit a turning point...and realized I was nearly finished.
Well, I thought I was at least.
I placed the case screws in their respective holes and twisted them in. Subsequently, I turned the watch around to admire myhackjob handy work.
But to my dismay, the dial had lifted from the rehaut edge. Everytime I add the case screws to the VR3130 the dial lifts from the rehaut. To note, the case is a 3135 case-- which should be accepting of the 3130.
I'm sure I have f'd something up, but I just don't know what. Any guidance would be appreciated.
Thank you in advance.
After several hours of thinking I was in over my head... I finally hit a turning point...and realized I was nearly finished.
Well, I thought I was at least.
I placed the case screws in their respective holes and twisted them in. Subsequently, I turned the watch around to admire my
But to my dismay, the dial had lifted from the rehaut edge. Everytime I add the case screws to the VR3130 the dial lifts from the rehaut. To note, the case is a 3135 case-- which should be accepting of the 3130.
I'm sure I have f'd something up, but I just don't know what. Any guidance would be appreciated.
Thank you in advance.