Mini review + some photos of PAM 164N H-factory
As a follow-up to this thread: http://forum.replica-watch.info/vb/showthread.php/interested-in-buying-112145?t=112145
Got my 164N from H-factory yesterday, re-assembled, cleaned, regulated and water-proofed and could not be happier. The crystal and dial on this watch are the best I've seen on reps - so clean and crispy, especially in the sun! Case looks and feels awesome, brushing is top quality and very subtle and CG is tight and closes with a nice confident click.
Inside, nothing ground-breaking - and I didn't take any photos during the assembly. Asian 7750 with printed OP rotor that wont fool a blind kid but at least clean and nicely regulated to +5 secs. Movement ring appears to be made of titanium as it is very light. Screws and movement tabs are of reasonable quality but not as good as Noob stuff on my 029M. Caseback is heavy with good deep engravings and Swiss-made on the inner side.
The best thing so far is QR buttons are appearing to be very well made - butter-like release function, very secure once pushed in and show to sign of any stress after I did a change over 5-7 times just to test them. Well done on this one, H-factory.
The photos are with gen croc; also it seems on photos that the cyclop is off-centered againts DW but this is just an angle, it is dead-on centered in real life
Anyways, here you go:
As a follow-up to this thread: http://forum.replica-watch.info/vb/showthread.php/interested-in-buying-112145?t=112145
Got my 164N from H-factory yesterday, re-assembled, cleaned, regulated and water-proofed and could not be happier. The crystal and dial on this watch are the best I've seen on reps - so clean and crispy, especially in the sun! Case looks and feels awesome, brushing is top quality and very subtle and CG is tight and closes with a nice confident click.
Inside, nothing ground-breaking - and I didn't take any photos during the assembly. Asian 7750 with printed OP rotor that wont fool a blind kid but at least clean and nicely regulated to +5 secs. Movement ring appears to be made of titanium as it is very light. Screws and movement tabs are of reasonable quality but not as good as Noob stuff on my 029M. Caseback is heavy with good deep engravings and Swiss-made on the inner side.
The best thing so far is QR buttons are appearing to be very well made - butter-like release function, very secure once pushed in and show to sign of any stress after I did a change over 5-7 times just to test them. Well done on this one, H-factory.
The photos are with gen croc; also it seems on photos that the cyclop is off-centered againts DW but this is just an angle, it is dead-on centered in real life
Anyways, here you go:
