3D Printed Replacement Hytrel Bezel Gaskets

[Watch9194]

Hello all, I purchased a VSF 126610LV with a damaged bezel gasket and attempted to install a 116610 gasket which was just a mm too short and caused it to bend/get mangled and unusable.

I have a industrial 3D printer and nylon filament on hand, does anyone have the dimensions or a STEP or even better yet an STL file for this bezel retaining gasket ring? If so, I can start printing out a bunch out of nylon as I know this is one part that is hard to source.

 

[Amguy1]

Hi, how far did you get with this


Sent from my iPhone using Tapatalk

 

[Watch9194]

I have successfully made some replacements, message me for details.

 

[Poglavnik]

I have successfully made some replacements, message me for details.

Hello, do you have the correct dimension for a 41mm VSF Sub? Do you recommend strictly Nylon or is an other material also sufficient? I've tried previously PLA that was not sturdy enough in my opinion. Thanks in advance!