326M

[Tubbs]

I have a 326M, its a lovely watch but after running the chrono, then reset.

Both dials at 3 and 6 have not gone back correctly the one at 3 is now ponting towards 2 and the one a 6 towards 1.

Does anyone know if there is an easy fix or if I should send back to dealer?
Ive had the watch about 5 weeks but only wore it last 2 days as I was awaiting a new strap.

Everything else seems ok apart from the now misalignment.

Any advice appreciated.

 

[civic4982]

This is a known complication with 7750s.
So common in fact that many will claim that you should not even use your chrono unless your watch has been professionally service.

I would hope that a TD would replace it but you may be better off sending it to a watchsmith for movement service. It may cost around $150 so keep that in mind. At least then it would be good to go!

If it were me I would spend the extra bucks and have it serviced instead of sending it back which may mean taking months to get it back.

 

[Tubbs]

Yeah, may look into this, or wait till it breaks! dial at 6 is actually spot on, its only dial at 3, starting to get use to it!