Big day today, my first respectable rep was delivered!
The release news of the 8500 rep has taking a bit of the wind from my sails, but I'm quite happy with this UPO (asian ETA) that has just arrived.
NOW ITS TIME BRING ON THE MODS!
I'm not going to go overboard (I hope), but I'm thinking of the following... Would love to have some input from the more experienced.
1. AR crystal from Sunnydale -> Already on the way...
:
2. Gen Crown & Tube to in hopes to increase reliability,usability, water resistance? Should I do this now, or use it until it breaks/crossthreads, etc?
3. seal He valve - this looks like it goes through the case fully on my watch. Is this normally done with Gen parts or can the rep parts be sealed for water tightness?
4. Datewheel - If I order Gen parts for Crown & Tube, I might as well do the datewheel (with the 1-9 Bold) since the part is so inexpensive.
I really am quite satisfied (on day 1) with the dial/hands and the pearl alignment doesn't bother me (yet) - so I may just leave these alone (for now).
I'm in the USA and will be looking for a trusted 'executor' of the items above. Sizing the bracelet is about the extent of my skills
All advice/thoughts are welcome.
The release news of the 8500 rep has taking a bit of the wind from my sails, but I'm quite happy with this UPO (asian ETA) that has just arrived.

NOW ITS TIME BRING ON THE MODS!
I'm not going to go overboard (I hope), but I'm thinking of the following... Would love to have some input from the more experienced.
1. AR crystal from Sunnydale -> Already on the way...
2. Gen Crown & Tube to in hopes to increase reliability,usability, water resistance? Should I do this now, or use it until it breaks/crossthreads, etc?
3. seal He valve - this looks like it goes through the case fully on my watch. Is this normally done with Gen parts or can the rep parts be sealed for water tightness?
4. Datewheel - If I order Gen parts for Crown & Tube, I might as well do the datewheel (with the 1-9 Bold) since the part is so inexpensive.
I really am quite satisfied (on day 1) with the dial/hands and the pearl alignment doesn't bother me (yet) - so I may just leave these alone (for now).
I'm in the USA and will be looking for a trusted 'executor' of the items above. Sizing the bracelet is about the extent of my skills
All advice/thoughts are welcome.