- 26/8/12
- 80
- 9
- 8
Hi Everyone,
I just thought I would post a quick guide as to how I restore my scratched Plexi Crystals, I use 4 different materials to do this and they are: -
Wet and Dry Sandpaper (Four different grades ranging from Medium Coarse to Fine which I pre cut into squares and staple together for ease of use).
Water (Lots and lots)
Cotton Wool
And most importantly, a great product called Polywatch (Available online, eBay, and Amazon etc).
So here is an old Smiths watch I am going to restore. As you can see, the Crystal looks pretty bad with scratches and some deep gouges.
Firstly I use the coarsest grade paper and PLENTY of water and rub the crystal down until it is smooth and there are no deep gouges left. It will look scratched and cloudy, but DONT panic!
So onto the next grade down. The crystal will feel a lot smoother after this pass and the clouding will look less "scratchy".
OK, so now onto the next grade down. Again, the clouding will remain but look a bit less "scratchy".
Now onto the final grade paper. This is just to smooth things out further.
Looks even worse than when we started eh? Not to worry, now we grab our Cotton Wool and Polywatch.
All we need to do now is put a small drop onto the Crystal and work it round and round for a minute using a little pressure as we go.
We can do this a couple of times until finally, the Crystal looks clear and shiny.
I hope you find this helpful and spend a lot less on new Plexi's
I just thought I would post a quick guide as to how I restore my scratched Plexi Crystals, I use 4 different materials to do this and they are: -
Wet and Dry Sandpaper (Four different grades ranging from Medium Coarse to Fine which I pre cut into squares and staple together for ease of use).
Water (Lots and lots)
Cotton Wool
And most importantly, a great product called Polywatch (Available online, eBay, and Amazon etc).
So here is an old Smiths watch I am going to restore. As you can see, the Crystal looks pretty bad with scratches and some deep gouges.
Firstly I use the coarsest grade paper and PLENTY of water and rub the crystal down until it is smooth and there are no deep gouges left. It will look scratched and cloudy, but DONT panic!
So onto the next grade down. The crystal will feel a lot smoother after this pass and the clouding will look less "scratchy".
OK, so now onto the next grade down. Again, the clouding will remain but look a bit less "scratchy".
Now onto the final grade paper. This is just to smooth things out further.
Looks even worse than when we started eh? Not to worry, now we grab our Cotton Wool and Polywatch.
All we need to do now is put a small drop onto the Crystal and work it round and round for a minute using a little pressure as we go.
We can do this a couple of times until finally, the Crystal looks clear and shiny.
I hope you find this helpful and spend a lot less on new Plexi's
