I see many franken Daytona’s here and there, could help to post them here with specifications.
116500
Noob SA4130 base V2
Gen crystal and gaskets
Gen hands
Gen barrel and mainspring
Case shaped on lugs and left side case
Arf claps, dial, bezel, V2
Band brushed like gen is
Movements fully serviced with also gen auto wind module and the gen 4130 upper bridge
116515 individual build
Noob SA4130 base
Gen crystal and gaskets all
Gen hands set
Gen mainspring
Movement fully serviced
Aftermarket dial with gen saphirs index
Gen rubber B strap
Aftermarket brown ceramic bezel, same size gen
Difficulties on build?
On the 116515 none, all fit in perfectly, even gen hands
On the 116500, a nightmare on gen hands to fit in, need to mod them a little, the subdials ones, 2 of them and the seconds chrono hands too,
Shaved the ARF dial was easy, just have to go carefully and slowly.
On both need to shaved the outside gen crystal gasket, they fit for steel bezel and not ceramic ones, 0,2 mm to fat, I braked one ceramic bezel before understand!!!
Servicing done by my watchmaker, Harleysta91, who made a very good job, one was over oiled and the other not too bad at all but on both metallic parts and graphite dust, so IMHO servicing is a must do.
After servicing, used them one month and after return to my watchmaker to check all run as have to.
Envoyé de mon iPhone en utilisant Tapatalk
116500
Noob SA4130 base V2
Gen crystal and gaskets
Gen hands
Gen barrel and mainspring
Case shaped on lugs and left side case
Arf claps, dial, bezel, V2
Band brushed like gen is
Movements fully serviced with also gen auto wind module and the gen 4130 upper bridge
116515 individual build
Noob SA4130 base
Gen crystal and gaskets all
Gen hands set
Gen mainspring
Movement fully serviced
Aftermarket dial with gen saphirs index
Gen rubber B strap
Aftermarket brown ceramic bezel, same size gen
Difficulties on build?
On the 116515 none, all fit in perfectly, even gen hands
On the 116500, a nightmare on gen hands to fit in, need to mod them a little, the subdials ones, 2 of them and the seconds chrono hands too,
Shaved the ARF dial was easy, just have to go carefully and slowly.
On both need to shaved the outside gen crystal gasket, they fit for steel bezel and not ceramic ones, 0,2 mm to fat, I braked one ceramic bezel before understand!!!
Servicing done by my watchmaker, Harleysta91, who made a very good job, one was over oiled and the other not too bad at all but on both metallic parts and graphite dust, so IMHO servicing is a must do.
After servicing, used them one month and after return to my watchmaker to check all run as have to.
Envoyé de mon iPhone en utilisant Tapatalk
Last edited:
