- 26/5/20
- 852
- 271
- 63
Hey guys, I have a 1675 that was ready built through a TD and I'm pretty pleased with the overall look (needing a better dial). My problem is that the bezel turns VERY easily. I've done quite a bit of reading and I'm aware that it's a bidirectional bezel and isn't supposed to click, but when turning, should have some resistance. I've read some say that on theirs, they kind of have to push the bezel down wards in order to turn it freely.
It's my understanding that under the bezel is supposed to be a tension/friction washer. I'm assuming this is missing, but if so, wouldn't my bezel have a little wobble to it? It's otherwise fixed in place well, just spins very easily. There's literally zero play in the bezel now for movement that could press against a washer.
I've looked up where to buy the washer, but with my inexperience, I'd rather not pop the bezel off before I could get a little more knowledge.
Appreciate any insight you have. Thanks
It's my understanding that under the bezel is supposed to be a tension/friction washer. I'm assuming this is missing, but if so, wouldn't my bezel have a little wobble to it? It's otherwise fixed in place well, just spins very easily. There's literally zero play in the bezel now for movement that could press against a washer.
I've looked up where to buy the washer, but with my inexperience, I'd rather not pop the bezel off before I could get a little more knowledge.
Appreciate any insight you have. Thanks