1675 information

[SuperTopGun]

Guys an information a 27.3 mm dial can be mounted on a case gen spec 1675? Another question mounting a dg 3804 I will need a sealing ring? Thanks

 

[SuperTopGun]

Bump

 

[Solution6]

yodog has an article showcasing a comparison of two cases. (been trying to find the post again but with no luck, it was a Cartel vs Vietnam case comparison)

One was gen spec and from what I remember DGs might not work at all with gen spec cases and other movements need custom rings.

 

[Solution6]

A bit more searching generated results

https://forum.replica-watch.info/fo...-vs-vietnam-gen-spec-cases-a-photo-comparison

 

[SuperTopGun]

https://m.yukiwatch.com/catalog/item/6784664/10308371.htm I don't know if this can be fine for dg3804b

 

[yodog]

no it wont work - the movement tab cutouts are for ETA - the DG has different tab locations

 

[SuperTopGun]

no it wont work - the movement tab cutouts are for ETA - the DG has different tab locations

Can you give me an indication where to buy it?

 

[yodog]

they dont exist - tripdog and I make them ourselves. you have to take an existing ring and then mill down the locations so the tab runs over it

 

[SuperTopGun]

they dont exist - tripdog and I make them ourselves. you have to take an existing ring and then mill down the locations so the tab runs over it

Thank you very much for the information

 

[SuperTopGun]

yodog Excuse me for information is there a cheaper one than yuky da to edit? $ 50 seems like a lot, advice