- 6/2/15
- 216
- 25
- 28
I made a thing! All credit for the design and the software goes to the developers.
The winder was printed in PLA and is controlled by an Arduino nano. The winder turns 20 times in a cycle and then pauses for 35min, then repeats.
Short video of it running:
https://www.youtube.com/watch?v=6AP_86T57Jc
You can buy the printer files from here:
https://cults3d.com/en/3d-model/fashion/gyro-winder-watch-winder-remontoir-montre
and this is the software I used:
https://git.faked.org/jan/openwatchwinder
The winder was printed in PLA and is controlled by an Arduino nano. The winder turns 20 times in a cycle and then pauses for 35min, then repeats.
Short video of it running:
https://www.youtube.com/watch?v=6AP_86T57Jc
You can buy the printer files from here:
https://cults3d.com/en/3d-model/fashion/gyro-winder-watch-winder-remontoir-montre
and this is the software I used:
https://git.faked.org/jan/openwatchwinder