AP New V2 dead

[dreK]

Good evening everyone, here I explain my problem I just received the roo rubberclad from JF. I bought it via a contact I have there. after going up the crown the mechanism starts to do its work properly only there is a problem the watch stops about every 4 hours ... I would like to know if it is possible to revise this kind of mechanism so that the watch can work properly? if anyone can help me thank you

Envoyé de mon MI MAX 3 en utilisant Tapatalk

 

[dreK]

Nobody Can help me here plz ??

Envoyé de mon MI MAX 3 en utilisant Tapatalk

 

[macarone]

Sounds like you need to go back to your TD first, if all fails there send it to a watch repair specialist, and if that fails just enjoy it, wear it in good health every four hours!


I've gotten burned over Cheryl Tiegs,
Blown up for Raquel Welch.
But when I wind up in the hay it's only hay, Hey Hey

 

[dreK]

Thks mate , I would like to take it to a watchmaker, but do you know if the A3126 mechanisms from JF are repairable?? I contacted TD who told him to send him back

Envoyé de mon MI MAX 3 en utilisant Tapatalk

 

[dreK]

Hi everyone, here IS my watchmaker report ;

Hello, here is a photo of the movement, indeed it is a copy Valjoux 7750. But it is a low quality movement, poorly adjusted, fragile because the watch is heavy and the slightest shock can have a fatal impact.

I put a little oil on the pivots, controlled, disassemble the balance and the exhaust to rotate the cog vacuum. I did not notice anything anormal. I will control it on the "range simulator" in order to see its good functioning and its precision.

 

I will keep you informed as soon as I have news, have a nice Sunday, cordially, Eric



Envoyé de mon MI MAX 3 en utilisant Tapatalk

 

[dreK]

Picture

Envoyé de mon MI MAX 3 en utilisant Tapatalk