Where to find stem for rep Omega?

[Itsriker]

Hello RWI!
I am looking for a stem to replace this broken one. Any idea where to find one? I do not know the movement, or the manufacturer, as it was given to me already broken. Also, is it worth it to try and remove the broken stem from the crown, or just get a new crown?

Images below.

Thanks in advance!

 

[Itsriker]

 

[mclarendude]

That movement looks like it is based on an ST6 movement. Same rotor design.

If it is the case, it could be this one.

https://www.ebay.com/c/1848748493

I am not 100% sure though.

 

[Hor-Fan]

If you can’t find the correct stem, you can use one of these to repair the broken one.


https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/233439229708

 

[Itsriker]

That movement looks like it is based on an ST6 movement. Same rotor design.

If it is the case, it could be this one.

https://www.ebay.com/c/1848748493

I am not 100% sure though.

Thank you! I'll do some looking around at that movement and see if it matches! Thanks again for your eye!

 

[Itsriker]

If you can’t find the correct stem, you can use one of these to repair the broken one.


https://rover.ebay.com/rover/0/0/0?mpre=https://www.ebay.com/ulk/itm/233439229708

This is brilliant!! I may go this way anyways as at least a temporary fix. Is .9mm just a safe guess? Thanks for letting me know about these!

 

[Hor-Fan]

It should work, you just need to get the broken stub out of the crown. I’d recommend heating the stub up a bit with a lighter to release the cement, then holding it tight in pliers while unscrewing the crown.

 

[Itsriker]

It should work, you just need to get the broken stub out of the crown. I’d recommend heating the stub up a bit with a lighter to release the cement, then holding it tight in pliers while unscrewing the crown.

Thanks for the tip! I'll try that!