Need help identifying a movement screw

[KJ2020]

Hey guys, the movement is Miyota 9015. I need a replacement screw. It is one of only 2 screws that are the same size. I think it holds the upper plate to the rest of the movement. Dimensions are:
Thread diam: 0.6 mm
Thread length: 1.8 mm
Head diameter: 1.5 mm
The problem is sites selling screws refer to them as the type they are i.e., bridge, plate, case, etc. I cannot find the replacement by the measurements alone and I am not certain what the name of this screw would be. Please help!
Thanks, KJ

 

[tripdog]

.








Never forget the importance of a decimal point.

If the correct measurements are 0.6, 1.5, 1.8 then I have one - it's yours for $1000.

 

[KJ2020]

Haha tripdog, you're a hoot!
I had just gotten up when I posted that.

 

[Rx4Time]

Here's a parts list for miyota....not sure if it'll help?

http://miyotamovement.com/sp/sp_parts_search.php?open=9015

 

[KJ2020]

Here's a parts list for miyota....not sure if it'll help?

http://miyotamovement.com/sp/sp_parts_search.php?open=9015

Thanks Teddy, I'll have a look...

 

[KJ2020]

I found a diagram of the Miyota 9015 and a parts list. I've looked at all the screws listed, and don't see the one I need. It's not showing in the diagram or the list. I'm thinking maybe the one I need is part of the decorator plate the factory workers add to the base movement.

Still looking...

 

[Rx4Time]

Thanks Teddy, I'll have a look...

Ok, I was thinking the same thing. I didn't see it either which was why I just linked you vs giving an actual part number. Best of luck!

 

[tripdog]

I found a diagram of the Miyota 9015 and a parts list. I've looked at all the screws listed, and don't see the one I need. It's not showing in the diagram or the list. I'm thinking maybe the one I need is part of the decorator plate the factory workers add to the base movement.

Still looking...

When I said I had one I meant the screw - if the measurements with a decimal point are correct, I have the screw you need. PM me your address.

 

[capice]

if Tripdog's doesn't fit, just let me know, I have a lot of gen parts...

 

[KJ2020]

When I said I had one I meant the screw - if the measurements with a decimal point are correct, I have the screw you need. PM me your address.

Thanks tripdog, you the man! I have PM'ed you.

The measurements are indeed

Thread diam: 0.6mm
Thread length: 1.8mm
Head diam: 1.5mm

 

[KJ2020]

Thanks teddy875 and capice01 for your help with this!