• Tired of adverts on RWI? - Subscribe by clicking HERE and PMing Trailboss for instructions and they will magically go away!

royal oak 41mm 15400 blue JF different thickness

nautilus1956

You're Saying I Can Sell?
30/10/18
26
5
3
the same watch on dif. sites have dif. thickness:
ts station - 10 mm
trusty time - 11mm
intime watch - 10.5

anybody looked into this?

Gen thickness is: 9.8
 

MrOptional

Active Member
8/10/18
393
166
43
If I recall correctly they are about 10.5nm. All JF V3 will be the same thickness regardless of where you buy it from. And yes they are thicker than gen but you can get them thinned down by professional modder but will cost money.
 

N0tail_

Active Member
1/6/17
323
204
43
If I recall correctly they are about 10.5nm. All JF V3 will be the same thickness regardless of where you buy it from. And yes they are thicker than gen but you can get them thinned down by professional modder but will cost money.

Legend and/or Slaughter have both stated that not every 15400 can be thinned down to 9.9. Sometimes you just get lucky.
 

nautilus1956

You're Saying I Can Sell?
30/10/18
26
5
3
Thank you for the comments. This was my understanding as well. All JF V3 should have the same thickness. Somehow different vendors show diff. numbers.
 

MrOptional

Active Member
8/10/18
393
166
43
Yeah I think it's just whatever they show on their website, they all get them from the same place.
 

C Master

General RWI Dogsbody
Staff member
Global Moderator
Administrator
Certified
Top Poster Of Month
7/10/15
65,717
84,145
113
Ireland
There is no consistency as far as I am aware. They vary from 10.8mm to 11.2mm, the xtal sits proud by anywhere from 5mm - 6mm, leaving a case thickness of between 10.3mm to 10.6mm. JF have always been the same. You can manage to shave between 0.4mm to .6mm off them.
 
  • Like
Reactions: legend and vcappp

nautilus1956

You're Saying I Can Sell?
30/10/18
26
5
3
Thank you. I just assumed that if done by the same factory dimensions should be consistent.
 

blsk

Looking Around
19/11/18
4
0
0
If I recall correctly they are about 10.5nm. All JF V3 will be the same thickness regardless of where you buy it from. And yes they are thicker than gen but you can get them thinned down by professional modder but will cost money.


Where do i found the modders?
 

legend

The RWI Dragon
Staff member
Global Moderator
Certified
20/9/10
60,330
74,609
113
Where I need to be.
If I recall correctly they are about 10.5nm. All JF V3 will be the same thickness regardless of where you buy it from. And yes they are thicker than gen but you can get them thinned down by professional modder but will cost money.

M, remember not $50 and not 30min and not using a saw lol :laugh:
 
  • Like
Reactions: Allure and d3xophen

MrOptional

Active Member
8/10/18
393
166
43
@legend :) :)

blsk: This is how you do it:

PRU7T.jpg


but in all seriousness you can get the watch and PM legend, he can hook you up with some good modders :)
 
Last edited: